UCE-CT321L-V1.12
Released on 2024-12-18
Recent changes;
* Fixed a bug in Short Circuit Mode algorithm.
* Fixed some bugs in Browse File menu.

UCE-CT321L-V1.11
Released on 2024-12-11
Recent changes;
* HDMI output has been increased from 480x272 pixels to 480x290 pixels. This allows support for RTD2660 based HDMI LCDs.
* Added support for controlling the device with touch panel (for HDMI monitors with touch panel).
* Activated the LCR meter menu.
* In the file browser menu, the maximum number of files in a folder has been increased from 50 to 256 (Files could not be opened if there were more than 50 files in a folder. This number was increased to 256).
Some optimizations.

UCE-CT321L-V1.10
Released on 2024-11-12
Recent changes;
* Fixed offset error in CH-A in Tracer Algorithm.

UCE-CT321L-V1.09
Released on 2024-10-28
Recent changes;
* Improved the communication protocol with the UCE-LCR-1 device.
* Fixed some bugs.
* Some optimizations.

UCE-CT321L-V1.08
Released on 2024-10-04
Recent changes;
* Improved the Short Circuit Finder algorithm.
* Improved the device's Host USB communication protocol.

UCE-CT321L-V1.07
Released on 2024-09-02
Recent changes;
* Improved the display of calculated values on the screen.
* When you enter the "0:/system/mouse drivers/drivers" folder in the "Browse Files" menu, the driver files in this folder can be installed by clicking the INSTALL button. Thus, the driver file setting suitable for the mouse used with the device can be easily made.
* Improved the device's Host USB communication protocol.

UCE-CT321L-V1.06
Released on 2024-07-13
Recent changes;
* Improved the communication algorithm with the control assistant.

UCE-CT321L-V1.05
Released on 2024-04-08
Recent changes;
* Improved the OPC mode algorithm.
* Optimized the comparison algorithm.

UCE-CT321L-V1.04
Released on 2024-03-29
Recent changes;
* Added OPC (one probe comparison) Mode. With this mode, two boards can be compared by making consecutive measurements using only the CH-A channel.
* Some optimizations.

UCE-CT321L-V1.03
Released on 2024-02-23
Recent changes;
* Fixed a bug in the short circuit finder algorithm.
* Some optimizations.

UCE-CT321L-V1.02
Released on 2024-02-20
Recent changes;
* Added a "SC Mode" (Short Circuit Mode) button to the short circuit finder menu. When this button is activated, an analog gauge animation simulating the distance to the short circuit point is activated.
* Improved the zener diode and standard diode detection algorithm. Voltages Vf and Vz are displayed bidirectionally with positive and negative directions.
* Improved the DC measurement algorithm.
* Some optimizations.

UCE-CT321L-V1.01
Released on 2024-01-22
Recent changes;
* Fixed a bug in the Measurement calibration algorithm.
* Fixed a bug in the Screen calibration algorithm.
* Improved the Impedance curve display algorithm.
* Some optimizations.